International Journal of Research Studies in Agricultural Sciences
Volume-2 Issue-7, 2016, Page No: 14-21
Application of Atterberg Model on Surface and Sub-Grade Soils
for Foundation Mechanics and Design Suitability
I.D. Edem & M.E. Nkereuwem
1.Department of Soil Science and Land Resources Management, University of Uyo, Nigeria.
2.Department of Soil Science, Faculty of Agriculture, Federal University Dutse Jigawa State, Nigeria
Citation : I.D. Edem & M.E. Nkereuwem, Application of Atterberg Model on Surface and Sub-Grade Soils for Foundation Mechanics and Design Suitability International Journal of Research Studies in Agricultural Sciences . 2016;2(7):14-21.
Abstract
The study location is within the coastal plain sand of Akwa Ibom State. The area lies within a subhorizontal
geomorphologic terrain with a measure of undulations arising from uneven surface area erosion. The
study revealed that the soils are loose, coarse texture with 78 – 80% sandy fractions having single grain
structure from unconsolidated materials of recent alluvial deposits. The soils are strongly acid in reaction with
pH values between 4.8 and 5.8 which could be attributed to leaching of the basic cations to lower depth.
Organic carbon content ranged from moderately low 1.50% to high 2.38% due probably to high surface litter
and vegetation cover. Since the ultimate bearing capacity depends upon the angle of internal fraction (ф) and
hence the penetration number (N), it was related directly to the N at profiles 1, 2, 3 and 4 from the existing
surface, cohesion value of 25 kN/m2 was applied and the allowable bearing pressure of 18.5 kN/m2, 17.1 k/Nm2,
54 k/Nm2, and 66 kN/m2 were obtained for profiles 1, 2, 3 and 4 respectively by applying a factor of safety of
3.0. The higher the elevation, the higher the plasticity and the swelling potential; and the lower the bearing
capacity and strength of the building sub-grade.